46
46 EN
EPIR3 User Manual v1.3
Main Settings
Function Command Value Range / Comment Example
Arm the
system
XXXX_ARM The system will send you a text conrmation
by return.
1111_ARM
Disarm the
system
XXXX_DISARM The system will send you a text conrmation
by return.
1111_DISARM
Change the
exit delay
timer
XXXX_
EXITDELAY:YY
YY = [0... 600]
value is in seconds
When you exit your protected building, having
just armed the system, you have to leave
within a specied time to avoid activating the
alarm. (The manufacturer pre-set default is
15 seconds.) During this time the detector will
ignore any motion. This period is called the exit
delay. By default, while the time-out is running,
the LED will blink once a second.
1111_EXITDELAY:20
Disable the
exit delay
timer
XXXX_
EXITDELAY:0
1111_EXITDELAY:0
NOTE: A combination of dierent phone number formats is allowed to use.
NOTE: The underscore symbol ‘_’ in these instructions represents a space. So when typing an SMS text
message, replace the underscore symbol with a single space.
To Next Page
Loading...
