47
47EN
EPIR3 User Manual v1.3
Zone Settings
Function Command Value Range / Comment Example
Edit zone alarm
text
XXXX_Zn:
NewTextHere
Zn = [Z1... Z34] 1111_Z1:
Motion_detected
Disable a zone XXXX_Zn:OFF Zn = [Z1... Z34] 1111_Z5:OFF
Enable a zone XXXX_Zn:ON Zn = [Z1... Z34] 1111_Z7:ON
Change the entry
delay timer
XXXX_
ENTRYDELAY:n,YY
n = [Z1... Z34],
YY = [0... 65535]
value is in seconds
When you enter your protected building, you
have to disarm the system within a specied
time to avoid activating the alarm (manufacturer
pre-set default is 15 seconds). During this time
the detector will ignore any motion. This period
is called entry delay. By default, while the time-
out is running, the LED will bling once a second.
1111_ ENTRYDE-
LAY:1,25
Disable the entry
delay timer
XXXX_
ENTRYDELAY:Zn,0
Zn = [Z1... Z34] 1111_
ENTRYDELAY:Z5,0
Check your
system and zone
status
XXXX_STATUS The system will reply to the user who sent the
SMS text message, with the following up-to-
date
information:
• system status (armed/disarmed);
• status of zones & PGM outputs (ON/OFF);
• zone alarm texts;
• PGM output names.
1111_STATUS
PGM Output Settings**
Function Command Value Range / Comment Example
Rename PGM output XXXX_Cn:
NewNameHere
Cn = [C1... C32] 1111_C2:Pump
Turn ON PGM output /
set PGM output startup
status to ON
XXXX_Cn:
ON or XXXX_OutputName:ON
Cn = [C1... C32] 1111_Pump:ON
NOTE: The underscore symbol ‘_’ in these instructions represents a space. So when typing an SMS text
message, replace the underscore symbol with a single space.
To Next Page
Loading...
