Eldes EPIR3 - Page 48

48
48 EN
EPIR3 User Manual v1.3
PGM Output Settings**
Turn OFF PGM output /
set PGM output startup
status to OFF
XXXX_Cn:
OFF or XXXX_OutputName:OFF
Cn = [C1... C32] 1111_C3:OFF
Turn ON PGM
output for a specied
time period
XXXX_Cn:ON:
HH.MM.SS or XXXX_
OutputName:ON:HH.MM.SS
Cn = [C1... C32]; HH = hour,
[00... 23]; MM = minutes,
[00... 59]; SS = seconds,
[00... 59]
1111_C3:ON:
13.23.48
Turn OFF PGM
output for a specied
time period
XXXX_Cn:
OFF:HH.MM.SS or
XXXX_OutputName:
OFF:HH.MM.SS
Cn = [C1... C32]; HH = hour,
[00... 23]; MM = minutes,
[00... 59]; SS = seconds,
[00... 59]
1111_Pump:OFF:
15.20.01
**- The EPIR3 system supports wireless PGM outputs allowing connection and control of various electrical appli-
ances: water pumps, heating, lighting, blinds etc. The maximum number of PGM wireless outputs which can be
connected to the EPIR3 system is 32.
Alarm Duration Settings
Function Command Value Range / Comment Example
Change system
alarm duration
XXXX_SIREN:T T = [0... 5]
vale is in minutes
1111_SIREN:4
Check system
alarm duration
XXXX_SIREN The system will reply to the user who sent
the SMS text message, with the current
alarm duration set
1111_SIREN
System Status Information
Function Command Value Range / Comment Example
Check the status
of your system
XXXX_INFO The system will reply to the user who sent the SMS
text message, with the following up-to-date
information:
• system date & time;
• system status (armed/disarmed);
• GSM signal strength level;
• mains power status;
• state of zones (OK/alarm).
1111_INFO
NOTE: The underscore symbol ‘_’ in these instructions represents a space. So when typing an SMS text
message, replace the underscore symbol with a single space.