Eldes EPIR3 - Page 50

50
50 EN
EPIR3 User Manual v1.3
Alarm Notication Settings
Function Command Value Range / Comment Example
Enable SMS to all
users simultane-
ously in case of
alarm
XXXX_
SMSALL:ON
By default, in case of alarm the system sends an SMS
message to User 1. If the system does not receive a
successful SMS message delivery conrmation in 20
seconds from the recipient, the SMS message is sent
to User 2, and if there is still no delivery conrmation
received, to Users 3, 4 and 5, but the sequence will
stop as soon as a delivery conrmation is received.
You may wish to congure the system to send these
messages to all pre-programmed user numbers
simultaneously when alarm occurs.
1111_SMSALL:ON
Disable SMS text
message to all
users simultane-
ously in case of
alarm
XXXX_
SMSALL:OFF
1111_SMSALL:OFF
External Power Supply & Backup Battery Status Notication Settings
Function Command Value Range / Comment Example
Disable SMS text
message regard-
ing the external
power supply
XXXX_M:OFF The EPIR3 will let you know when the mains 230V
power supply fails or recovers. In some remote plac-
es where the mains power supply is unreliable, you
may wish to congure the system to ignore these
changes. This command applies to User 1 only.
1111_M:OFF
Enable SMS text
message regard-
ing the external
power supply
XXXX_M:ON 1111_M:ON
Disable SMS text
message regard-
ing the battery
replacement
XXXX_BA-
TREPORT:
OFF
The system checks the backup battery resistance
every 10 days. If the backup battery is disconnected
or needs to be replaced (if more than 2,5 resistance
is detected), the system sends an SMS message
to User 1. You may wish to congure the system to
ignore these changes.
1111_
BATREPORT:OFF
Enable SMS text
message regard-
ing the battery
replacement
XXXX_BA-
TREPORT:
ON
1111_
BATREPORT:ON
NOTE: The underscore symbol ‘_’ in these instructions represents a space. So when typing an SMS text
message, replace the underscore symbol with a single space.