EasyManua.ls Logo

Eldes EPIR3 - Page 51

Eldes EPIR3
124 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
51
51EN
EPIR3 User Manual v1.3
Temperature Notication Settings
Function Command Value Range / Comment Example
Set temperature
MIN and MAX
values
XXXX_TEMP:
MIN:MAX
MIN = minimum temperature pairedary, [-10...
40] C; MAX = maximum temperature pairedary,
[-10... 40] C.
1111_TEMP:-
10:30
Check the
temperature
XXXX_TEMP
The system will reply to the user who sent the
SMS text message, with the temperature value
measured by the pre-selected (using ELDES
Conguration Tool software) temperature sensor.
1111_TEMP
System Control from Any Phone Number Settings
Function Command Value Range / Comment Example
Unblock unknown
incoming num-
bers
XXXX_STR:ON By default, the EPIR3 alarm system can only be
accessed from each of up to ten mobile phones that
you program into it..
To allow access from any phone number you need to
enable the current feature, which will allow all pass-
word holders to access the system.
1111_STR:ON
Block unknown
incoming numbers
XXXX_STR:OFF 1111_STR:OFF
Remote Listening
Function Command Value Range / Comment Example
Hear what is
happening in your
property
XXXX_MIC You can listen in to what is happening at your protected
property whenever you want by sending
this SMS text message. The system will make a phone call to
you and enable the microphone in EPIR3. You must answer
the call within 20 seconds to listen in to what is happening
in your property. If you do not pick up, the system will stop
trying and will return to its previous state.
NOTE: If there is an alarm the system will automatically
make a call so that you can listen to what is happening in the
property. In this case, the system will try the pre-pro-
grammed numbers in order until its call is answered. The
phone call in the event of alarm will be made UNLESS „Disa-
ble ring from the system in case of alarm“ has been selected,
see „alarm notication settings“ above.
1111_MIC
NOTE: The underscore symbol ‘_’ in these instructions represents a space. So when typing an SMS text
message, replace the underscore symbol with a single space.

Table of Contents

Related product manuals