Eldes EPIR3 - Page 52

52
52 EN
EPIR3 User Manual v1.3
Detector Sensitivity Level Settings
Function Command Value Range / Comment Example
Change the
sensitivity level of
the detector
XXXX_LEVEL:YY YY = [20... 99]
The greater the value, the lower the sensitivity
level of the detector.
The EPIR3 device is pre-set by the manufac-
turer at the optimal detector sensitivity level.
However, in some cases, for instance where the
system is installed in windy premises, the air
ow can cause false alarms. In this case you can
reduce the sensitivity level.
1111_LEVEL:35
Check the sensi-
tivity level of the
detector
XXXX_LEVEL 1111_LEVEL
Wireless Device Management
Function Command Value Range / Comment Example
Disable wireless
module
XXXX_RF:OFF The system disables the built-in wireless
module
1111_RF:OFF
Enable wireless
module
XXXX_RF:ON 1111_RF:ON
Pair a wireless
device to the
system
XXXX_SET:YYYYYYYY YYYYYYYY = 8-character wireless device
ID code
1111_
SET:5261841A
Remove a wire-
less device from
the system
XXXX_DEL:YYYYYYYY YYYYYYYY = 8-character wireless device
ID code
1111_
DEL:5261841A
Replace a wireless
device by another
wireless device of
the same model
1111_REP:YYYYYY
<ZZZZZZZZ
YYYYYYYY = old 8-character wireless
device ID code; ZZZZZZZZ = new 8-char-
acter wireless device ID code
1111_
REP:5261841A
<41286652
Verify free wire-
less channels
XXXX_STATUS_FREE The system will send you a text by return,
with the number of available free wire-
less channels.
1111_STATUS_FREE
NOTE: The underscore symbol ‘_’ in these instructions represents a space. So when typing an SMS text
message, replace the underscore symbol with a single space.