Appendix F: Zone Types
iConnect Installation Manual
134
Gas
Gas zones are always active. In the event of a gas leak, these zones generate a Gas alarm. Gas zones are typically used
with methane/propane/butane or carbon monoxide gas detectors. Gas alarms sound a distinctive siren pattern to easily
distinguish them from other alarms. A gas alarm causes the siren to sound until the alarm is restored; the siren cut-off
does not apply to gas alarms.
Event Group: Fire
Flood
Flood zones are always active. When triggered, Flood zones generate a Water alarm. These zones are designed for use
with EL-2661 flood sensors.
Event Group: Burglary
Environmental
Environmental zones are always active. When triggered, these zones generate an Environmental alarm. These zones are
designed for applications that monitor environmental conditions such as temperature or humidity. If the Bell option is
enabled for Environmental zones, the system sounds trouble tones from the keypad. These tones are sounded until the
user presses on their keypad. Environmental alarms are not affected by the expiry of the siren cut-off.
Event Group: Burglary
No Motion
No Motion zones are used to monitor the activity of disabled or elderly people. If a No Motion zone has not been
triggered within a pre-defined period of time (0 to 72 hours), a No Motion event message is sent to the central station.
Event Group: Medical
Not Used
This zone type disables the sensor output. All alarm transmissions from the sensor are ignored though the sensor may
still be used to activate HA units in Home Automation applications.
Event Group: Not applicable
To Next Page
Loading...