Electronics Line 3000 iConnect - Event Options for Central Station Reporting; Vocal Message Dialer Event Options

10 Communications
iConnect Installation Manual
75
Disable Firmware update is not allowed.
User Initiated The user must perform SW Update from the Service menu in order to establish a connection
– see p. 36, 4.8.14 Remote Firmware Update.
Table 10-2: Remote FW Update
10.9. Event Options for Central Station Reporting
System events are divided into a number of different event groups. This division allows you to enable or disable
reporting or Two-Way Audio for a specific group of events.
The different event groups are as follows:
 Burglary [#1]
 Fire [#2]
 Open/Close (arm/disarm) [#3]
 Service [#4]
 Power [#5]
 Peripherals [#6]
 RF Jamming [#7]
 Medical
10.9.1. Event Reporting
You can enable or disable event reporting per Event Group. This allows you to filter the type of events that are reported
to the central station.
To enable/disable reporting for an event group:
1. From the Programming menu, select Communications, Event Options [955].
2. Select an Event Group.
3. From the event group’s sub-menu, select Report [#1].
4. Select Enabled or Disabled.
10.9.2. Restore Reporting
For each event group, you can determine whether restore messages will be sent.
To enable/disable restore reporting for an event group.
1. From the Programming menu, select Communications, Event Options [955].
2. Select an event group.
3. From the event group’s sub-menu, select Report Restore [#2].
4. Select Enabled or Disabled.
10.9.3. Two-Way Audio
For Burglary, Fire and Medical event groups, there is an additional option that enables Two-Way Audio for that event
group – see p. 39, 5.2.2 TWA Alarm Reporting.
To enable/disable Two-Way Audio for an event group:
1. From the Programming menu, select Communications, Event Options [955].
2. Select an Event Group (Burglary, Fire or Medical).
3. Select TWA [#3].
4. Select Enabled or Disabled.
10.10. Vocal Message Dialer Event Options
Events reported using the Vocal Message Dialer are divided into event groups that correspond with the pre-recorded
event messages. This allows you to enable or disable the Vocal Message feature for a specific group of events. For
further information on this feature, see p. 67, 10.3 Vocal Message Dialer.