4 Advanced System Operation
iConnect Installation Manual
31
4. Edit the descriptor using the alphanumeric keypad.
5. Press when you have finished editing.
4.4.4. User Code Partition Set.
In partitioned systems, controlled/non-controlled/limited user codes can be assigned to full arming, partition 1,
partition 2, or to both partitions and
full arming. To program the Partition set option:
1. From the main menu, select User Codes [4].
2. Select a controlled, non-controlled or limited code.
3. From the code’s sub-menu, select Partition Set [#3]; the code’s current Partition Set setting is displayed.
Partition Set Description
123 (F + P1 + P2) The user code is assigned to both partitions and full arming
2 (P1) The user code is assigned to partition 1
3 (P2) The user code is assigned to partition 2.
Table 4-1: User Code Partition Set
4. Use the keys 1, 2 and 3 to toggle the current setting. Press 3when finished.
Note: If you assign the User Code to both partitions, assign it to the full arming also.
4.5. Follow-Me
The Follow-Me feature is designed to notify the user that certain events have occurred. The events that are sent to the
Follow-Me telephone number are those events that the user is authorized to view in the event log; events that can be
viewed only by the installer are not sent to the Follow-Me number – see p. 130, Appendix E: Event Table. If using the
TWA Follow-Me feature, the audio channel is opened after alarm events only.
To edit the Follow-Me number:
1. From the main menu, select Telephone, Follow-me Number # [51].
2. Enter a telephone number for Follow-Me communication. If using the SMS Follow-Me feature, this
number must be for a cellular phone with the capability to receive SMS messages.
Note: You may only access Follow-Me programming if the protocol for Account 3 is programmed as SMS or
TWA Follow-Me.
4.6. Speed Dial Numbers
Speed Dial feature allows you to program up to five telephone numbers that you can call from your Control System. To
program one of the Speed Dial numbers:
1. From the main menu, select Telephone # [5].
2. Select the speed dial number to be edited [52 – 56].
3. From the Speed Dial's submenu, sub-menu, select Phone Number [#1].
4. Enter up to 16 digits. Use the
key to enter "*", "#", "," (pause), "T" (switch to DTMF tone dialing), "P"
(switch to pulse dialing) or "+" (international code). Use the
key to delete one character at a time.
Press .
To program the Speed Dial interface:
1. From the main menu, select Telephone # [5].
2. Select the speed dial number to be edited [52 – 56].
3. From the Speed Dial's submenu, sub-menu, select Interface [#2].
4. Select the interface type (GSM or PSTN).
4.7. Event Log
The event log records the last 1022 events the system has undergone. The log uses the FIFO (First In, First Out) method,
automatically erasing the oldest event when the log is full.
To Next Page
Loading...