Electronics Line 3000 iConnect - Battery Type; Partition; T014 A Standard

To Next Page

To Previous Page

9 System Options

iConnect Installation Manual

9.21. Battery Type

The battery type must be defined according to the battery supplied with the system (for example, if the battery sticker

reads 1500 mAh, choose 1.5 Ah, if 3000 mAh, choose 3.0 Ah).

To program the battery type:

1. From the Programming menu, select System Options, Battery Type [9421].

2. Select the battery type.

9.22. Partition

9.22.1. Partition Setting

To program the Partition option (see p. 24, Arming/Disarming – Partitioned Systems ):

1. From the Programming menu, select System Options, Partition, Setting [94231].

2. Select Enabled or Disabled.

9.22.2. Partition Descriptor

Each partition can be assigned a 16-character descriptor. These descriptors help to identify which partition the

triggered zone belongs to in the event log and in SMS Follow-Me messages.

To edit a partition descriptor:

1. From the Programming menu, select System Options, Partition [9423].

2. Select Partition 1 [#2] or Partition 2 [#3].

3. Edit the descriptor using the alphanumeric keypad, then press .

9.23. T014A Standard

To turn on the T014A functionality, perform the following procedure:

Note: For this functionality to function, the EN-50131 standard must be chosen.

1. From the Programming menu, select System Options, T014A, Enable T014A [94241].

2. Select Enable or Disable.

To reset messages:

1. From the Programming menu, select System Options, T014A, Message Reset [94242].

The system Prompts: "Messages Reset OK?"

2. Press "" to reset the messages.