3 Basic System Operation
iConnect Installation Manual
21
Key Function
Service call, see p.39, 5.2.1 Service Call.
Audio message playback/recording. See p.
33, 4.8.2 Message Center.
+
SOS Panic Alarm. See p. 27, 3.12.7, Alarm
Activation.
Table 3-10: Front Panel Keypad Functions
3.9. Audible Notification
The following table is a summary of tones that audibly notify system status.
Status Tones Description
Positive
Acknowledge
1 long tone. The preceding action was accepted.
Negative
Acknowledge
5 low tones. The preceding action was not accepted (e.g. an incorrect
user code entry).
Exit Delay/
Entry Delay
External Siren: 4 tones.
Internal Siren: 4 tones or
Continuous tones.
Continuous tones quicken
when there are 15 seconds
remaining and quicken
again when there are 5
seconds remaining.
The exit/entry delay is counting down.
The number of tones sounded during each delay is
determined in programming – see p. 53 8.5 Arming
Tones.
Chime 2-tone modulated
sequence (similar to a
doorbell).
A zone with the Chime option enabled has been opened –
see p. 46 7.3.5 Chime .
Arm 3-tone modulated
sequence (low to high)
sounded twice
The system has been armed using any of the arming
methods.
Disarm 3-tone modulated sequence
(high to low).
The system has been disarmed.
Home Automation Rapid 2-tone modulated
sequence.
An HA unit has been turned On or Off using a wireless
keypad or keyfob – see p. 54 8.6 Home Automation
Tones .
System Trouble 4 rapid tones sounded
once per minute.
A trouble condition has been detected, press for
further details. For Fire Trouble Tones, there is a
programmable option to repeat fire-related trouble tones
until the problem has been taken care of – see p. 55,
8.7.3 Fire Trouble Tones.
Table 3-11: Audible Notification
3.9.1. System Trouble Tones
In the event of system trouble, the iConnect Control System sounds a series of tones to alert the user. To silence these
tones, press and scroll through the system trouble list displayed on the LCD. When the trouble condition is restored,
it is removed from the system trouble list.
Note: For this feature to function, Trouble Tones must be enabled in programming – see p. 54, 8.7.1 System
Trouble Tones.
System trouble tones are not sounded from 10:00pm to 7:00am so as not to disturb household members who may be
asleep. However, you can program the system to immediately annunciate telephone trouble at all times – see p. 55,
8.7.2 Telephone Trouble Tones.
To Next Page
Loading...