10 Communications
iConnect Installation Manual
76
The vocal message event groups and their associated system events are as follows:
Burglary [#1]
Alarm from Zone (excluding Gas and Environmental zones)
Zone Tamper
Tamper
Duress
Fire [#2]
Zone Fire Alarm
User Activated Fire Alarm
Panic [#3]
Zone Panic Alarm
User Activated Panic Alarm
Medical [#4]
Zone Medical Alarm
Zone Medical Alarm
User Activated Alarm
No Motion
System Trouble [#5]
Battery Low
Transmitter Low Battery
AC Loss
Media Loss
Device Trouble
Communication Trouble
Transmitter Out of Synch.
Control System Transmitter Out of Synch.
Supervision Loss
Zone Trouble
FM Jamming
Arm [#6]
Full Arm
Part Arm/Partition 1 Arm
Perimeter Arm/Partition 2 Arm
Disarm [#7]
Disarm/Partition 1 Disarm/Partition 2 Disarm
Disarm after Alarm
Water [#8]
Zone Water Alarm (Flood)
To enable/disable the vocal message for an event group:
1. From the Programming menu, select Communications, VM Event Opt. [956].
2. Select an event group.
3. Select Enabled or Disabled.
To Next Page
Loading...