5 Telecontrol and Two-Way Audio
iConnect Installation Manual
38
Press "3" to fully arm the system.
Press "4XX" to turn HA unit #XX ON.
Press "430" to activate PGM output (Unit 30)
Press "5XX" to turn HA unit #XX OFF.
Press "530" to deactivate PGM output (Unit 30)
Press "6" to disarm the system.
Press "9" to cancel the siren.
For partitioned systems, arming and disarming commands are different:
Press "31" to fully arm the system.
Press "32" to arm partition 1.
Press "33" to arm partition 2.
Press "61" to disarm the entire system.
Press "62" to disarm partition 1.
Press "63" to disarm partition 2.
Notes: The Arm/Disarm, Home Automation, PGM on/off, and Siren canceling can also be executed
at any time during a Two-Way Audio session.
Error beeps (three tones) sound in case of a wrong command.
To clear the last command, press "" or "#".
The duration of the call is determined by the TC/VM Timeout -- see p. 72, 10.6.11
Telecontrol/Vocal Message Timeout. Ten seconds before the timeout expires, two short DTMF
tones are sounded. To extend the call, press "7" on your telephone. This command restarts the
timeout.
4. To disconnect before the end of the timeout, press "" then "#" on your telephone.
5.1.5. Arm/Disarm DTMF Commands
During a Telecontrol call, you can arm and disarm the system remotely using the DTMF commands (see above). When
arming the system in this way, the system is armed immediately without an exit delay.
5.1.6. HA and PGM DTMF commands
During a Telecontrol call, you can turn On and Off the Home Automation units using the DTMF commands "4XX" (HA
unit #XX On) and "5XX" (HA unit #XX Off). PGM unit is defined as HA Unit 30. You can activate and deactivate PGM
using the DTMF commands "430" (PGM On) and "530" (PGM Off).
5.1.7. Siren Cancel ("Bell Cancel")
The siren is muted during Two-Way Audio communication. At the end of the call, the siren is re-activated (if the Siren Cut-
Off has not yet expired). During the call, pressing "9" on your telephone cancels the re-activation of the siren.
5.1.8. Central Station Two-Way Audio
Central Station Two-Way Audio is an alarm verification feature that enables the central station operator to establish
Two-Way Audio communication with the Control System within ten minutes of an alarm.
To make a Central Station TWA call:
1. Call the Control System either using the double call method (PSTN) or directly (Cellular); when the
Control System picks up, two DTMF tones are sounded.
2. Enter the Central Station TWA code (Code 30) on your telephone within 15 seconds.
Note: Do not enter your user code until you hear the two DTMF tones. Any digits entered before the tones
are sounded are disregarded by the system.
3. If the TWA mode is defined as "Simplex" (see p. 72, 10.6.13 TWA Mode), the audio channel opens in
Listen mode (microphone active/speaker mute). To switch to Speak mode, press "1" on your telephone.
To switch back to Listen mode, press "0" on your telephone.
To Next Page
Loading...