Electronics Line 3000 iConnect - Page 6

Electronics Line 3000 iConnect

143 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Table of Contents

Default Chapter3
- Table of Contents3
1 Introduction7
- Documentation Conventions7
- Specifications8
- System Overview8
- Hardware Layout10
2 System Installation15
- Pre-Installation Planning15
- Installation Procedure16
- Back Tamper19
- Installing Hardwire LCD Keypads19
- Internet Communication Setup (Not Relevant to PSTN-Only Configuration)20
3 Basic System Operation22
- Front Panel Layout (LCD Top Cover)22
- Front Panel System Status Leds (LCD Top Cover)22
- Front Panel Keypad and Hardwire LCD Keypad23
- LCD Display24
- Front Panel Layout (LED Top Cover)25
- System Status Leds (LED Top Cover)26
- Arming Status Leds (LED Top Cover)26
- Front Panel Keypad (LED Top Cover)26
- Audible Notification27
- Arming and Disarming - Unpartitioned Systems28
- Arming/Disarming - Partitioned Systems30
- Additional Arming Options32
4 Advanced System Operation34
- Menu Navigation34
- Cancel Report34
- Zone Bypassing/Unbypassing35
- User Codes35
- Follow-Me37
- Speed Dial Numbers37
- Event Log37
- Service Menu38
5 Telecontrol and Two-Way Audio43
- Incoming Calls43
- Outgoing Calls45
6 Home Automation and PGM Control47
- Keypad Control47
- Keyfob Control47
- Telephone Control47
- Scheduling (Not Relevant to48
7 Devices49
- Device Descriptors49
- Wireless Devices49
- Zones50
- Keyfobs54
- Keypads55
- Repeaters56
- Wireless Siren56
- Smartkeys57
8 Entry/Exit Timers and System Tones59
- Entry/Exit Delay59
- Arm on Exit59
- Supplementary Entry Delay59
- Entry Deviation59
- Arming Tones59
- Home Automation Tones60
- System Trouble Tones60
- Tones Options61
9 System Options62
- Swinger Setting62
- Code Lockout62
- Arm/Disarm Options62
- Panic Alarm63
- AC Loss Delay63
- Display Options64
- PGM Output Options65
- Guard Code66
- No Arm" Indication67
- Jamming Detection67
- No Motion" Time67
- Microphone/Speaker Options67
- Vocal Messages67
- Installer Access68
- Auto Log View (for Future Use)68
- Daylight Savings68
- Standard Type68
- Entry/Exit Trouble69
- Report Fail Trouble69
- Immediate Arming from Wuapp69
- Battery Type70
- Partition70
- T014A Standard70
10 Communications71
- System Reporting71
- Report Cycles72
- Vocal Message Dialer73
- Remote Programming74
- Service Call76
- Communications Options76
- GSM Options (Not Relevant to PSTN Only or Ethernet Configuration)78
- TWA Event Report Options80
- Event Options for Central Station Reporting81
- Vocal Message Dialer Event Options81
11 Internet Options (Relevant to Ethernet/Gprs & ELAS Configuration)83
- ELAS Connection Parameters83
- Control System Parameters83
- GPRS Network Parameters83
- LAN Network Parameters84
12 Home Automation Programming86
- X10 Overview86
- HA Units86
- House Code88
- HA Control88
13 System Initialization89
- Initialization89
- Default Program Restore89
- Clear User Codes89
- Clear Wireless Transmitters89
- Find Modules89
Appendix A: Menu Structure90
Appendix B: Transmitter Installation97
- Iconnect PIR Sensors (EL-2745/2745PI)97
- PIR Sensors (EL-2600/EL-2600PI/EL-2645/EL-2645PI)100
- Magnetic Contact (EL-2601)103
- Universal Transmitter (EL-2602)104
- Glassbreak Sensor (EL-2606)106
- Smoke Detector (EL-2603)109
- Smoke Detector (EL-2630EN)109
- Keyfobs (EL-2611/EL-2714)115
- Wireless Terminal (EL-2724)115
- Wireless Keypad (EL-2640)117
- Flood Sensor (EL-2661)118
- Repeater (EL-2635)119
- Transmitter Specifications123
Appendix C: Web User Application125
- Options Available from Main Page127
Appendix D: Installing IP Cameras (Relevant to Gprs/Ethernet & ELAS Configuration)133
Appendix E: Event Table136
Appendix F: Zone Types139