10 Communications
iConnect Installation Manual
73
To program the PIN code:
1. From the Programming menu, select Communications, Comm. Options, GSM Options, PIN Code
[954142].
2. Edit the four-digit PIN code, then press .
3. Power up the Control System to apply the new PIN Code definition.
Note: The new PIN code takes effect only after the System is powered up.
If a wrong PIN code was programmed in the system, a System Trouble is generated, PIN Code Error message is
displayed, and GSM communication of any kind is not available. In this case, the SIM card must be reactivated.
To reactivate a SIM card:
1. Program the correct PIN code in the Control System (see above), then disconnect the Control System
from all the power sources.
2. Remove the SIM card from the GSM module and insert it into a cellular phone.
3. Turn on the cellular phone and enter the correct PIN code.
4. Re-install the SIM card into the Control System and apply power.
10.7.3. SMS Center
To edit the SMS Center telephone number:
1. From the Programming menu, select Communications, Comm. Options, GSM Options, SMS Center
[954143].
2. Enter up to 16 digits. Use the
key to enter "*", "#", "," (pause), "T" (switch to DTMF tone dialing), "P"
(switch to pulse dialing) or "+" (international code). Use the
key to delete one character at a time.
Press when finished.
10.7.4. SMS Command
The SMS Command option enables you to enable or disable the ability to send commands to the system via SMS. For
further information on SMS commands, see p. 26, 3.12.3 Remote Arming/Disarming via SMS and p. 41, 6.3 Telephone
Control.
To enable/disable SMS commands:
1. From the Programming menu, select Communications, Comm. Options, GSM Options, SMS Command
[954144].
2. Select Enabled or Disabled.
10.7.5. SMS Confirmation
After an SMS command is executed by the system, a confirmation message is returned to the sender’s mobile phone.
You can enable or disable this feature using this option.
To enable/disable SMS confirmation:
1. From the Programming menu, select Communications, Comm. Options, GSM Options, SMS Confirm
[954145].
2. Select Enabled or Disabled.
10.7.6. GSM Media Loss Time
The GSM Media Loss Time is a feature that is designed to control the amount of GSM media loss events registered in
the log and sent to the central station.
If, for a period defined in GSM ML Time parameter, the GSM signal has always been below the lower threshold, a
Media Loss event is registered in the log and sent to the central station.
The GSM Media Loss event is sent to the central station via PSTN only.
If, for a period defined in GSM ML Time parameter, since GSM media restore is detected, the GSM signal has always
been above the upper threshold, GSM Media Restore is registered in the log and sent to central station.
To disable the GSM Media Loss feature (cancel the GSM Media Loss events) enter 000.
To program the GSM Media Loss Time:
1. From the Programming menu, select Communications, Comm. Options, GSM Options, GSM ML Time.
[954146].
To Next Page
Loading...