Important Safety Instructions
BA_Elmasteam_8_Vers.07.2016 © Elma Schmidbauer GmbH
WARNING
Hot vapours/hot liquids
Injuries caused by scalding!
• Never open the drain cock when an excess pressure of > 0
up has built up in the pressure vessel!
• Observe the gauge display!
CAREFUL
Hot surface areas/hot vapours
Injuries caused by burns or scalding!
• Never reach into the area of the upper vents as they can
heat up during operation!
• The ventilation slots in the area of the safety valve can
become hot after triggering by escaping steam!
• Always wear suitable PPE
(e.g. protective gloves, protective footwear, protective
clothing)
• Place the device in the lock position during application
breaks.
• The device automatically switches off after expiry of the set
time limit.
INFORMATION
Parts in the device can be damaged!
The connected pressurised air must not exceed a pressure of 6
bar.
(Applies only to devices with optional compressed air inlet)
INFORMATION
Parts in the device can be damaged!
The connected water pipe system must not exceed the
maximum water pressure of 6 bar is not exceeded and the
minimum water pressure of 1.6 bar not fall below.
The connected water pipe system must not exceed the
maximum temperature of 20°C.
(Applies only to units with optional water pump)
To Next Page
Loading...
