Elma Elmasteam 8 basic - Page 77

Handling in Operation
© Elma Schmidbauer GmbH BA_Elmasteam_8_Vers.07.2016
77
the rotary knob into the possible range of values until the
values that can be set start to flash again.
7. Press the rotary knob to confirm the set value.
 The function
lock
illuminates. The device
switches after setting automatic to
lock
(Chapter
7.4.4).
8. Start with
1.
to assume an additional setting!
* Time to eco, after a set time between 0-7 hours, then the
set pressure range drops to 3 bar.
* Determine hardness, refer to the information data sheet
"Water Quality"
* Determine chlorine content, refer to the data sheet "Water
Quality"
7.4.6.1 Settings
INFORMATION
The factory setting values are highlighted in grey in the
Table 7.4.6.1.