MES53xx, MES33xx, MES23xx Ethernet Switch Series 46
command is used as follows:
1. Connect to a remote device from the switch via TELNET or SSH.
2. Return to the parent session (to the switch). Press <Ctrl+Shift+6>, release the keys and
press <x>. This will switch you to the parent session.
3.
session will be listed in the table.
4.
Privileged EXEC mode commands
Command line prompt in the privileged EXEC mode is as follows:
console#
Table 5.11. System management commands in the privileged EXEC mode
Use this command to restart the device.
- unit_id – stack unit number
reload in {minutes | hh:mm}
minutes: (1..999);
hh: (0..23), mm: (0..59).
Set the time period for delayed device restart.
hh: (0..23), mm: (0..59).
Set the device reload time.
Show statistics on CPU load.
Show statistics on the speed of ingress frames processed by
CPU.
Example use of the traceroute command:
console# traceroute ip eltex.com
Tracing the route to eltex.com (148.21.11.69) form , 30 hops max, 18 byte packets
Type Esc to abort.
1 gateway.eltex (192.168.1.101) 0 msec 0 msec 0 msec
2 eltexsrv (192.168.0.1) 0 msec 0 msec 0 msec
3 * * *
Table 5.12. Description of 'traceroute' command results
The hop number of the router in the path to the specified network node.
The network name of this router.
The IP address of the router.
The time taken by the packet to go to and return from the router. Specify for each
packet transmission attempt.
The errors that occur during execution of the traceroute command are described in the table.
Table 5.13. 'traceroute' command errors
Packet transmission timeout.
To Next Page
Loading...
Need help?
General
