ELTRA CS-2000 - Solenoid Valves Cleaning

Service
108
Tube to squeeze:
Leak location:
13
Exhaust valve (V9)
14
Flow meter (25)
15
CO2-Paths (26)
16
SO3-Trap (27) or oxidizing furnace
tube (28)
17
SO2-Path (29) or flow sensor (30)
18
Regulator valve (V6)
20
Bypass valve (V4), check for 24 V
DC on the coil
21
Purge valve (V3), check for 0 V DC
on the coil
22
Lance valve (V2), check for 24 V DC
on the coil
ATTENTION do not cause a short circuit while measuring, otherwise the drivers will be
destroyed. See chapter “Electronic drivers malfunctioning”.
– If the voltages on V2, V3, or V4 are wrong, then replace the electronic drivers.
Pos: 7.10 /0025 Üb erschriften/E LTRA 1.1 Übersc hriften/11 Sol enoid valves clea ning ELTRA @ 6\mod_13 69643206541_9.d ocx @ 4246 5 @ 2 @ 1
5.5 Solenoid valves cleaning
Pos: 7.11 /0010 E LTRA/0015 s ervice_instructio ns/CS-2000_s ervice/15 Ser vice_CS-2000/15 30 Modul Cle aning solenoid valves @ 9\mod _1425543480 470_9.docx @ 74 766 @ @ 1
Fig.
92
: Solenoid valve 2/2
2
4
5
7
1
2
3
4
5
7
1
3
66
3-13-1