ELTRA ELEMENTRAC ONHp2 - Page 19

Description
19
Position
Component
Description
1
Catalyst furnace
Is used for the processing of analysis gases
2
Reagents
Are used for the processing of analysis gases
3
Sample receipt
This is where the sample to be analysed is inserted.
4
Furnace cover
The impulse furnace is located behind the cover.
5
Dust filter
This filter removes particles from the gas flow.
6
Crucible
This is where a crucible must be placed before the
analysis.
7
Crucible carrier
8
Main switch
Position 0: Turns off the device
Position 1: Preheats the device
Position 2: Puts the device ready for analysis