Troubleshooting on the ELEMENTRAC ONH-p 2
48
8 Troubleshooting on the ELEMENTRAC ONH-p 2
1. Use the ELEMENTS software in order to determine which fault has occurred on the
analyser and correct it in accordance with the error message of the ELEMENTS software
2. If you are not able to fix the error yourself, please contact the customer service.
In order to contact the customer service, please see „Repairs“.
9 Cleaning
9.1 Exterior cleaning
Danger to life from electric shock
Cleaning with water on current-carrying parts
− Any cleaning work with water on the device can lead to life-threatening
injuries from electric shock, if the device is not disconnected from the power
supply.
• Only perform cleaning work with water on the device when the device
is disconnected from the power supply.
Housing damage
Use of organic solvents
− Organic solvents can damage the lacquer.
• The use of organic solvents to clean the housing is not permitted.
The outside of the device ELEMENTRAC ONHp2 must be cleaned on a regular basis.
In order to clean the outside of the device, please proceed as follows:
1. Pull the power plug on the device.
2. Please wait until the device has cooled down sufficiently.
3. Moisten a suitable cloth until it is slightly damp.
4. Clean the outside surfaces of the device with the slightly damp cloth.
5. Please wait until the device is completely dry.
6. Plug the power plug back in again.
The outside of the device has been cleaned.
To Next Page
Loading...
Need help?
General
