EasyManuals Logo

ELTRA ELEMENTRAC ONHp2 User Manual

ELTRA ELEMENTRAC ONHp2
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
Maintenance
72
.
NOTICE
Do not use a Torx® screwdriver with a ball head. The screws may be very tight and the
ball head could thereby tear off and damage the screw.
• Remove the electrode of the furnace from below.
• Clean the inside of the furnace with a dry cloth.
• Insert the new electrode into the furnace from the bottom up. The electrode has a
coding to enable a better orientation. This must point to the right.
• Fasten the electrode with the three screws

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ELTRA ELEMENTRAC ONHp2 and is the answer not in the manual?

ELTRA ELEMENTRAC ONHp2 Specifications

General IconGeneral
BrandELTRA
ModelELEMENTRAC ONHp2
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals