Emerson Daniel Danalyzer 1000 - CPU RS-232 Configuration

MODEL 1000 SEP 2005
INSTALLATION AND SETUP
3-51
3.4.4.2 CPU RS-232 Configuration
CPU COM1 RS-232 Configuration
COM1 is I/O mapped at 3F8H and utilizes a 16550 type DART contained in the Super I/O chip.
When used in RS-232 mode, COM1 is terminated via the Multi-I/O connector at J1. The
configuration details and the pin definitions when used with the cable (P/N 3-2350-083) are shown
here:
Figure 3-10. COM1 RS-232
CPU COM2 RS-232 Configuration
COM2 is I/O mapped at 2F8H and utilizes a 16550 type UART contained in the Super I/O chip.
When used in RS-232 mode, COM2 is terminated via the multi-I/O connector at J1. The
configuration details and the pin definitions, when used with the cable (P/N 3-2350-083), are shown
here:
Figure 3-11. COM2 RS-232