MODEL 1000 SEP 2005
MAINTENANCE
5-5
5.2.2 Routine Maintenance Procedures
a. Complete the GC System Maintenance Checklist bi-monthly. Place the sales order number,
date and time on the form and file it. This gives you a basis for comparison in the future if
you need it.
b. Save a Chromatogram of the operating Analyzer on the PC with the MON2000 software.
Print configuration, calibration, and raw data reports and file them with the Maintenance
Check List. Also upload the current application to the PC with the MON2000 software.
c. Check the printer paper roll (if used) to ensure that a sufficient supply of paper remains.
Check carrier and calibration gas supplies.
d. There is no routine maintenance to be performed on the GC Controller.
5.2.3 Contract Service
Emerson Process Management offers maintenance (service) programs that are tailored to fit specific
requirements. Contracts for service and repair can be arranged by contacting the Daniel Measurement
Services (DMS), a division of Emerson Process Management, at the address or telephone number
on the Customer Repair Report at the back of this manual. There are also contact numbers and
information available via www.empersonprocess.com/daniel.
To Next Page
Loading...
