SEP 2005 MODEL 1000
INSTALLATION AND SETUP
3-76
Silicon Disk Mode
The GC uses the M-Systems DiskOnChip (DOC) device. The mode is controlled via pins 13-14 on
jumper block at J11 as shown here:
Figure 3-30. DiskOnChip Jumper Block
Jumpering for DOC mode with EPROM, RAM, or FLASH installed effectively acts to disable
the Solid State Disk and similarly, when a DOC device is installed and the jumper is selected
for standard devices the DOC is disabled.
Device Type Selection
Before using the M-Systems the proper device type must be selected by correctly jumpering J11. The
supported device type jumperings are shown here:
Figure 3-31. DiskOnChip Jumper Block J11
To Next Page
Loading...
