SEP 2005 MODEL 1000
OPERATION FROM LOCAL KEYPAD AND DISPLAY
4-12
(8)
Make time entries
All time entries are in seconds to the nearest 1/10
second.
(9)
Stop analysis runs
Press 5 (GC Control) and then 4 (HALT) to stop after
the present run.
Never edit the program during an analysis run from which data is to be used. Editing may cause
analysis errors for that particular run. Also, do not attempt to edit or stop the Controller during
a calibration sequence. Calibration errors may result.
(10)
Get out of screen saver
mode
To get out of the screen saver mode, press any key on
the keypad. (No keys pressed during one hour will
activate screen saver mode.)
(11)
Match entered data with
Data ID Tag
When entering data, a data identification tag will
appear to the right of the data box on the display to
indicate the type of entry expected. (For details, see
Section 4.2.4.)
(12)
Change "Yes" prompt
to "No"
Press the ALT+SPACE keys. The ALT+SPACE key
combination is used to toggle lists.
To Next Page
Loading...
