SEP 2005 MODEL 1000
DESCRIPTION
1-20
Response Factor: Correction factor for each component as determined by the calibration. It is
defined by the equation:
or
Where:
n
ARF
n
HRF
n
Area
n
Ht
n
Cal
= Area response factor for component “n” in area per mole percent (%)
= Height response factor for component “n”
= Area associated with component “n” in calibration gas
= Height associated with component “n” in mole % in calibration gas
= Amount of component “n” in mole % in calibration gas
Retention Time: The time (in seconds) that elapses between start of analysis (0 seconds) and the
sensing of the maximum concentration of each component by the Analyzer detector.
RI: Ring indicator (a serial port pin assignment).
RLSD: Received line signal detect (a digital simulation of carrier detect); see also, DCD (a serial
port pin assignment).
RTS: Request to send (a serial port pin assignment).
IN
RxD, RD, or S : Receive data, or signal in (a serial port pin assignment).
OUT
TxD, TD, or S : Transmit data, or signal out (a serial port pin assignment).
To Next Page
Loading...
