Emerson Daniel Danalyzer 1000 - Page 89

MODEL 1000 SEP 2005
INSTALLATION AND SETUP
3-35
Table 3-3. Modbus Slave Address (COM ID) DIP Switch Settings
Dip Switch Settings Switch Positions
COM ID 1 2 3 4 5
1 ON OFF OFF OFF OFF
2 OFF ON OFF OFF OFF
3 ON ON OFF OFF OFF
4 OFF OFF ON OFF OFF
5 ON OFF ON OFF OFF
6 OFF ON ON OFF OFF
7 ON ON ON OFF OFF
8 OFF OFF OFF ON OFF
RAM CLEAR
Dip Switch Setting Switch Positions
8
Clears RAM when unit powered down ON
Keeps RAM when unit powered down OFF
(4) When finished with the inspection or changes, reassemble the Controllers using the
following steps.
(a) For integrally-mounted Controllers, reattach the right side Access Panel and secure
with the four flat head screws.