5. From the Tank Name/Hub Position drop-down list select the tank to be configured
for hybrid density calculations.
6. Enter Local Gravity, Air Density and Vapor Density. These parameters are used for
calculating the Observed Density.
See the TankMaster WinOpi Reference Manual (Document No. 00809-0200-5110)
for more information on inventory calculations. Enter Upper and Lower Density
Limits for the Observed Density. Density values outside this range will be notified by
TankMaster.
7. Enter the P1 Sensor Position, i.e. the position of the center of the Liquid Pressure
sensor membrane.
Reference Manual Advanced configuration
00809-0100-2410 December 2019
Rosemount 2410 Tank Hub 169
To Next Page
Loading...
