5.5 LED
There are three Light Emitting Diodes (LED) on the Rosemount 2410 front for status and
error information.
Figure 5-3: The Rosemount 2410 has Three LEDs
A. Error LED (Red)
B. Status LED (Yellow)
C. Power On LED (Green)
The following color codes are used for the Rosemount 2410 LEDs:
Table 5-4: LED Color Codes
LED Type Color Description
Power On Green The green LED indicates that the Rosemount 2410 is powered on.
Status Yellow The yellow Status LED blinks at a constant rate of one flash every other
second in normal operation to indicate the Rosemount 2410 software
is running
Error Red The red Error LED is turned off in normal operation. If an error occurs,
the Error LED flashes a sequence that corresponds to a certain error
code.
Related information
Error LED
5.5.1
LED start-up information
When the Rosemount 2410 is starting, both the Status and the Error LEDs indicate
possible hardware or software errors as shown in Table 5-5:
Operation
Reference Manual
December 2019 00809-0100-2410
74 Reference Manual
To Next Page
Loading...
