3. Right-click and select the Program option (Program All option for multiple devices
programming). The device will automatically appear in the Program These Devices
pane.
4. In case the Devices folder in the WinSetup workspace was selected for multiple
programming, choose the desired device to be programmed from the Available
Devices pane and click the Move button.
5. Repeat for each device to be programmed. Use the Remove button if you wish to
change the list of devices to be programmed.
6. Click the Browse button to locate the flash program file. File extension *.cry is used
for these files.
Example
For a Rosemount 2410, a flash file name may typically look like:
2410_APPL_xxx_yy.cry, where “x” and “y” indicate software version.
Service and troubleshooting Reference Manual
December 2019 00809-0100-2410
86 Reference Manual
To Next Page
Loading...
