Emerson Process Management GmbH & Co. OHG S-7
X-STREAM XEFD
Instruction Manual
HASXEDE-IM-EX
03/2012
S
Safety Instructions
Safety Instructions
EXPLOSION HAZARD BY CONNECTIONS
Consider the waiting time statement on the front door label before opening,
if the analyzer is congured with selected measurement principles!
Do not open instrument when energized.
Ensure that external circuitry is disconnected or de-energized before
opening the instrument.
Ensure that all gas connections are made as labeled and are leak free.
Improper gas connections could result in explosion and death.
EXPLOSION HAZARD BY SAMPLE HANDLING
The X-STREAM analyzer may utilize not only sample gas but one or more
pressurized carrier gases and/or calibration gases.
If an external owmeter is required for ow control, legislative requirements
and instructions for installation in hazardous (classied) areas must be
considered.
EXPLOSION HAZARD BY MODIFICATION
Any addition, substitution, or replacement of components installed on or
in this device, must be certied to meet the hazardous area classication
that the device was certied to prior to any such component addition,
substitution, or replacement. In addition, the installation of such device or
devices must meet the requirements specied and dened by the hazardous
area classication of the unmodied device.
Any modications to the device not meeting these requirements, will void
the product certication(s).
Contact Emerson Process Management‘s customer service center for return
authorization.
To Next Page
Loading...
Need help?
General
