3-40 Maintenance
CadJet 3D Service Manual
4. Obtain the latest firmware revision, unpack the file and launch
the “XXX Firmware Utility.” File names may be different then
that listed above.
Click on “File”
Click on “Preferences”
Select the appropriate port that your printer is connected to
(either Modem or Printer.)
Drag and Drop the XXXX.ROM file (or the latest version) into
the “Spool Folder”.
Wait approximately 20 to 40 seconds later until you hear a
SINGLE beep, indicating the download was successful. You may
encounter a set of double beeps shortly after sending the
firmware file, but you must wait until you hear the SINGLE
beep.
5. After hearing the single beep, remove power from printer for 15-
20 seconds. Apply power to the printer. The printer should
initialize properly. Verify firmware revision by sequencing
through Utility Menu - Service Menu - About menu. Verify
firmware has been incorporated.
If the firmware download is not successful you may hear more
than 1 beep or complete silence. Check port connections and
return to step 4.
To Next Page
Loading...