ENCAD CADJET - Page 8

x
CadJet 3D Service Manual
Service Station Cleaning ..............................................................................3-3
Linear Encoder Strip Cleaning ......................................................................3-4
Cartridge Dimples Cleaning .......................................................................... 3-5
Flex Cable Contact Cleaning........................................................................3-6
Clean and Inspect Stepper Motor Gears.......................................................3-7
Clean and Inspect MPCB .............................................................................3-7
Clean and Inspect Carriage Assembly ......................................................... 3-8
Reseat Connectors on MPCB and Carriage Board.............................................. 3-8
Replace Carriage Bushings .............................................................................. 3-10
Servo Motor Winding Resistance Check ................................................................. 3-11
Stepper Motor Winding Resistance Check.............................................................. 3-12
Banding: Hardware vs Software ............................................................................... 3-13
Common Banding Causes ......................................................................... 3-14
Alignments/Adjustments......................................................................................... 3-16
Slide Shaft Profile Adjustment .......................................................................... 3-16
Head Height Alignment Procedure .................................................................... 3-19
Color Calibration ............................................................................................... 3-23
Deadband Alignments ...................................................................................... 3-26
Color Deadband Alignment......................................................................... 3-30
Paper Axis Calibration...................................................................................... 3-32
Diagnostics Menu ................................................................................................... 3-34
Limited Access Menu ............................................................................................. 3-37
Firmware Download/Upgrading for the PC ............................................................... 3-38
Firmware Download/Upgrading for the MAC ............................................................ 3-39
Internal Cabling and Signal Flow Diagrams ............................................................. 3-41
Chapter 4 Troubleshooting.................................................................. 4-1
Introduction ............................................................................................................... 4-1
No Power ...........................................................................................................4-1
Initialization Failure.............................................................................................4-2
Media Does Not Move ........................................................................................ 4-2
Internal ERROR “Carriage Axis Failure” .............................................................. 4-3
Internal ERROR “Encoder Sensor Failure” .......................................................... 4-5
Table of Contents (cont)
Chapter 3 Maintenance (cont)