PlasmaQuant 9100 (Elite) Security
9
The decontamination report is available from Service when registering the re-
turn. Service must refuse acceptance of contaminated devices. The sender may
be liable for damage caused by inadequate decontamination of the device.
2.4 Safety instructions: during operation
2.4.1 Basic safety information for operation
The operator must make sure that the device and its safety equipment is in sound
condition each time before starting up the device. This applies in particular after
each modification or extension of the device or its repair.
Observe the following notes:
¡ The device must only be operated if all protective equipment (e.g. covers and
doors) are in place, properly installed and fully operational.
¡ The sound condition of the protection and safety equipment must be checked
regularly. Any defects must be corrected as soon as they occur.
¡ Protective and safety equipment must never be removed, modified or switched
off during operation.
¡ Modifications, conversions and extensions to the device are only permitted after
consultation with Analytik Jena AG
. Unauthorized modifications can jeopardize
the device’s operational safety and may lead to limitations regarding the war-
ranty and access to customer service.
¡ During operation, free access to the connections, the power switch and the man-
ual plasma deactivation switch on the left housing panel must be ensured.
¡ The ventilation equipment on the device must be in good working condition.
Covered ventilation grilles or slots etc. may cause the device to break down or
may cause damage to it.
¡ Caution when handing quartz glass and glass parts. Risk of broken glass and
therefore risk of injury!
¡ Prevent any ingress of liquids into the interior of the device. Liquids may cause a
short circuit inside the housing.
¡ During operation, there is a risk of crushing at the hose pump. Long hair and
baggy clothing can become caught in the pump and drawn in. Wear suitable hair
protections and tight-fitting clothing.
2.4.2 Safety instructions – protection against explosion and fire
The device may not be operated in an explosive environment.
Smoking or handling open flames are prohibited in the room in which the device is
operated!
2.4.3 Safety instructions – electrical equipment
Lethal voltages may occur in the device! Contact with live components may cause
death, serious injury or painful electrical shock.
¡ Work on the electronics may only be carried out by the customer service of
Analytik Jena AG
and specially authorized technicians.
To Next Page
Loading...
