Endress+Hauser Levelflex FMP53 - Turning the Transmitter Housing

Levelflex FMP51, FMP52, FMP54 Mounting
Endress+Hauser 55
A
B
6Nm
6Nm
6Nm
6Nm
r
min
=100mm(4
”)
r
min
=100mm(4”)
3m(9ft) 3m(9ft)
A0014794
å 14
Connecting the cable. There are the following possibilities:
A Angled plug at the probe
B Angled plug at the electronics housing
6.3.6 Turning the transmitter housing
To provide easier access to the connection compartment or display module, the transmitter
housing can be turned:
max.350°
8mm
8mm
A0013713
1. Unscrew the securing screw using an open-ended wrench.
2. Rotate the housing in the desired direction.
3. Firmly tighten the securing screw. (1,5 Nm for plastics housing; 2,5 Nm for aluminium or
stainless steel housing).