Endress+Hauser Proline Promag P 100 - Incoming Acceptance and Product Identification; Incoming Acceptance Procedure

Proline Promag P 100
10 Endress+Hauser
Frequency output
Failure mode Choose from:
• Actual value
• Defined value: 0 to 12 500 Hz
• 0 Hz
Switch output
Failure mode Choose from:
• Current status
• Open
• Closed
PROFIBUS DP
Status and alarm
messages
Diagnostics in accordance with PROFIBUS PA Profile 3.02
Modbus RS485
Failure mode Choose from:
• NaN value instead of current value
• Last valid value
EtherNet/IP
Device diagnostics Device condition can be read out in Input Assembly
Operating tool
• Via digital communication:
– HART protocol
– PROFIBUS DP
• Via service interface
Plain text display With information on cause and remedial measures
Additional information on remote operation (→  48)
Web browser
Plain text display With information on cause and remedial measures
Light emitting diodes (LED)
Status information Status indicated by various light emitting diodes
The following information is displayed depending on the device version:
• Supply voltage active
• Data transmission active
• Device alarm/error has occurred
• EtherNet/IP network available
• EtherNet/IP connection established
Low flow cut off
The switch points for low flow cut off are user-selectable.