Proline Promag P 100
Endress+Hauser 5
Measuring system
One device version is available: compact version, transmitter and sensor form a mechanical unit.
Transmitter
Promag 100 Device versions and materials:
Compact, aluminum coated:
Coated aluminum AlSi10Mg
Configuration:
• Via operating tools (e.g. FieldCare)
• Also for device version with 4-20 mA HART, pulse/frequency/switch
output:
Via Web browser (e.g. Microsoft Internet Explorer)
• Also for device version with EtherNet/IP output:
– Via Web browser (e.g. Microsoft Internet Explorer)
– Via Add-on Profile Level 3 for automation system from Rockwell
Automation
– Via Electronic Data Sheet (EDS)
A0016693
Sensor
Promag P Nominal diameter range: DN 15 to 600 (½ to 24")
Materials:
• Sensor housing:
– DN 15 to 300 (½ to 12"): coated aluminum AlSi10Mg
– DN 350 to 600 (14 to 24"): carbon steel with protective varnish
• Measuring tubes
1)
: stainless steel 1.4301 (304) or 1.4306 (304L)
• Liner: PFA, PTFE
• Process connections: 1.0425 (316L)
2)
, 1.4571 (316L), A105, C22,
F316L
2)
, FE 410W B
2)
, HII, S235JRG2, S275JR
• Electrodes: 1.4435 (316L), Alloy C22, platinum, tantalum, titanium
• Seals: as per DIN EN 1514-1
• Ground disks: 1.4435 (316L), Alloy C22, tantalum, titanium
A0017703
1) For flanges made of carbon with Al/Zn protective coating (DN 15 to 300 (½ to 12")) or protective varnish
(DN 350 to 600 (14 to 24"))
2) With Al/Zn protective coating (DN 15 to 300 (½ to 12")) or protective varnish (DN 350 to 600 (14 to 24"))
Device architecture
A0021560
1 Possibilities for integrating measuring devices into a system
1 Control system (e.g. PLC)
2 EtherNet/IP
3 PROFIBUS DP
4 Modbus RS485
5 4-20 mA HART, pulse/frequency/switch output
6 Non-hazardous area
7 Non-hazardous area and Zone 2/Div. 2
To Next Page
Loading...
