Endress+Hauser Proline Promag P 100 - Certificates and Approvals; CE Mark; C-Tick Symbol; Ex Approval

Proline Promag P 100
52 Endress+Hauser
1 2
3
444
A0020903
1 Automation system
2 Computer with PROFIBUS network card
3 PROFIBUS DP network
4 Measuring device
Certificates and approvals
CE mark
The measuring system is in conformity with the statutory requirements of the applicable EC
Directives. These are listed in the corresponding EC Declaration of Conformity along with the
standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
C-Tick symbol
The measuring system meets the EMC requirements of the "Australian Communications and Media
Authority (ACMA)".
Ex approval
The measuring device is certified for use in hazardous areas and the relevant safety instructions are
provided in the separate "Safety Instructions" (XA) document. Reference is made to this document on
the nameplate.
The separate Ex documentation (XA) containing all the relevant explosion protection data is
available from your Endress+Hauser sales center.
ATEX, IECEx
Currently, the following versions for use in hazardous areas are available:
Ex nA
Category Type of protection
II3G Ex nA IIC T6-T1 Gc
cCSAus
Currently, the following versions for use in hazardous areas are available:
NI
Category Type of protection
Class I Division 2 Groups ABCD NI (Non-incendive version), NIFW parameter
1)
1) Entity and NIFW parameter in accordance with Control Drawings