Endress+Hauser Proline Promass E 100 - Page 105

Proline Promass E 100 Modbus RS485 Index
Endress+Hauser 105
Read access ............................. 44
Reading out data ......................... 48
Register addresses ........................ 45
Register information ...................... 45
Response time ........................... 45
Scan list ................................ 47
Write access .............................44
Modbus RS485 certification ....................99
Mounting dimensions
see Installation dimensions
Mounting location ...........................18
Mounting preparations ....................... 23
Mounting tools ............................. 22
N
Nameplate
Promass 100 safety barrier ..................15
Sensor ................................. 13
Transmitter ............................. 13
O
Operable flow range ......................... 84
Operating menu
Menus, submenus ........................ 37
Structure ............................... 37
Submenus and user roles ................... 38
Operating philosophy ........................ 38
Operation ................................. 63
Operation options ........................... 36
Operational display .......................... 38
Operational safety ............................9
Order code ................................ 13
Orientation (vertical, horizontal) ................ 19
Outlet runs ................................ 20
Output signal .............................. 84
Output variables ............................ 84
P
Packaging disposal .......................... 17
Parameter settings
For communication interface ................ 53
For low flow cut off ....................... 55
For monitoring of the tube filling ............. 56
For selecting and setting the medium .......... 52
For sensor adjustment ..................... 59
For system units ..........................50
For the operation ......................... 66
For the tag name ......................... 57
For the totalizer .......................... 59
Performance characteristics ....................87
Pharmaceutical compatibility ...................99
Post-connection check (checklist) ............... 34
Post-installation check ....................... 49
Post-installation check (checklist) ............... 23
Potential equalization ........................ 32
Power consumption ..........................86
Power supply failure ......................... 87
Pressure Equipment Directive .................. 99
Pressure loss ...............................94
Pressure-temperature ratings .................. 92
Process connections ..........................97
Process variables
Calculated .............................. 83
Measured ...............................83
Product safety ..............................10
Protecting parameter settings .................. 61
R
RCM-tick symbol ............................98
Read access ................................40
Reading measured values ......................63
Reading out diagnostic information, Modbus RS485 ..69
Recalibration ...............................77
Reference operating conditions ................. 87
Registered trademarks .........................7
Repair ....................................78
Repair of a device ........................... 78
Repairs
Notes ..................................78
Repeatability ...............................88
Replacement
Device components ........................78
Requirements for personnel .....................8
Response time ..............................89
Return ................................... 78
Rupture disk
Safety instructions ........................ 22
Triggering pressure ....................... 93
S
Safety ..................................... 8
Safety Barrier Promass 100 .................... 27
Sanitary compatibility ........................ 99
Sensor
Mounting ...............................23
Sensor heating ............................. 21
Sensor housing ............................. 93
Serial number .............................. 13
Settings
Adapting the measuring device to the process
conditions .............................. 65
Communication interface ................... 53
Device reset ............................. 75
Device tag .............................. 57
Low flow cut off .......................... 55
Medium ................................52
Partial filled pipe detection .................. 56
Resetting the totalizer ..................... 65
Sensor adjustment ........................ 58
Simulation .............................. 60
System units ............................ 49
Totalizer ............................... 59
Totalizer reset ........................... 65
Shock resistance ............................ 92
Signal on alarm .............................84
SIP cleaning ............................... 92
Software release ............................ 44
Spare part .................................78