Endress+Hauser Proline Promass F 500 - Page 119

Proline Promass F 500 Modbus RS485 Commissioning
Endress+Hauser 119
Parameter Prerequisite Description Selection / User
entry
Factory setting
Value 2 display A local display is provided. Select the measured value that
is shown on the local display.
• None
• Mass flow
• Volume flow
• Corrected volume
flow
• Target mass flow
*
• Carrier mass flow
*
• Density
• Reference density
• Concentration
*
• Temperature
• Carrier pipe
temperature
*
• Electronic
temperature
• Oscillation
frequency 0
• Oscillation
amplitude 0
*
• Frequency
fluctuation 0
• Oscillation
damping 0
• Oscillation
damping
fluctuation 0
• Signal asymmetry
• Exciter current 0
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Current output 1
• Current output 2
*
• Current output 3
*
• Custody transfer
counter
*
None
Value 3 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
the Value 2 display
parameter
(→  119)
None
0% bargraph value 3 A selection was made in the
Value 3 display parameter.
Enter 0% value for bar graph
display.
Signed floating-point
number
Country-specific:
• 0 kg/h
• 0 lb/min
100% bargraph value 3 A selection was made in the
Value 3 display parameter.
Enter 100% value for bar
graph display.
Signed floating-point
number
0
Value 4 display A local display is provided. Select the measured value that
is shown on the local display.
For the picklist, see
the Value 2 display
parameter
(→  119)
None
* Visibility depends on order options or device settings