Endress+Hauser Promag 53 - Page 157

Promag 53 PROFIBUS-DP/-PA 10 Technical data
Endress+Hauser 157
Promag H / DN 2...25 (remote version)
Fig. 72: Dimensions Promag H / DN 2...25 (remote version)
Wall mounting set for Promag H / DN 2...25
Abb. 73: Wall mounting set for Promag H / DN 2...25 (A = 125 mm, B = 88 mm, C = 120 mm, D = Ø 7 mm)
DN PN * DI L A B C K M
DIN
[mm]
ANSI
[inch]
DIN
[bar]
[mm] [mm] [mm] [mm] [mm] [mm] [mm]
2
− 16/40 2.25 86 213 148 65 43 M 6x4
4
− 16/40 4.5 86 213 148 65 43 M 6x4
8
− 16/40 9.0 86 213 148 65 43 M 6x4
15
− 16/40 16.0 86 213 148 65 43 M 6x4
– 1" 16/40 22.6 86 213 148 65 53 M 6x4
26
− 16/40 26.0 86 213 148 65 53 M 6x4
Overall fitting length will depend on the process connections
→ Page 160 ff.
* The permissible nominal pressure depends on the process connection and seal:
– 40 bar: flange, welded nipples (with O-ring seal)
– 16 bar: all other process connections
F06-xxHxxxxx-06-05-xx-xx-001
A
B
C
D
F06-xxHxxxxx-06-07-06-xx-000