Endress+Hauser Promag 53 - Turning the Local Display

Promag 53 PROFIBUS-DP/-PA 3 Installation
Endress+Hauser 43
3.3.6 Turning the local display
1. Remove the cover of the electronics compartment.
2. Press the side latches on the display module and remove it from the electronics
compartment cover plate.
3. Rotate the display to the desired position (max. 4 x 45° in each direction), and place
it back into the electronics compartment cover plate.
4. Screw the cover of the electronics compartment firmly onto the transmitter housing.
Fig. 28: Turning the local display (field housing)
F06-xxxxxxxx-07-xx-06-xx-000