Endress+Hauser Promag 53 - Brief Description of the Function Matrix

Promag 53 PROFIBUS-DP/-PA 5 Operation
Endress+Hauser 67
5.2.2 Brief description of the function matrix

Note:
• See the general notes on Page 68.
• Function descriptions → see the “Description of Device Functions” manual
1. HOME position
→  → Enter the function matrix
2. Select a block (e.g. USER INTERFACE)
3. Select a group (e.g. CONTROL)
4. Select a function group (e.g. BASIC CONFIGURATION)
5. Select function (e.g. LANGUAGE)
Change parameter / enter numerical values:
  key → Select/enter release code, parameters, counter values
 key → Save the entries
6. Exit the function matrix:
– Press and hold down Esc key (
 ) for longer than 3 seconds → HOME position
– Repeatedly press Esc key (
 ) → return step by step to HOME position
Fig. 44: Selecting functions and configuring parameters (function matrix)
F06-x3xxxxxx-19-xx-xx-xx-000