Promag 53 PROFIBUS-DP/-PA 5 Operation
Endress+Hauser 75
5.4 Operation with the PROFIBUS configuration
programs
The user can obtain special configuration and operating programs offered by the differ-
ent manufacturers for use in configuration. These can be used for configuring both the
PROFIBUS-DP/-PA parameters and all of the device-specific parameters. The prede-
fined function blocks allow uniform access to all the network and device data.
Note:
A step-by-step description of the procedure for commissioning the PROFIBUS interface
is given on Page 86 together with information about the configuration of device-specific
parameters.
5.4.1 FieldTool™ operating program
FieldTool™ is a universal service and configuration software package designed for the
PROline measuring devices. Connection is by means of the PROline service interface
(service adapter).
The functionality of FieldTool™ includes the following:
• Configuration of device functions
• Visualisation of measuring values (including data logging)
• Data backup of device parameters
• Advanced device diagnosis
• Measuring-point documentation
Note:
You can find more information on FieldTool™ in the following E+H document:
• System information: SI 031D/06/en “FieldTool™”
5.4.2 Commuwin II operating program
Commuwin II is a program for remote operation of field and control-room equipment.
Commuwin II can be used irrespective of the device type and the mode of communica-
tion (HART or PROFIBUS).
Note:
You can find more information on Commuwin II in the following E+H documents:
• System information: SI 018F/00/en “Commuwin II”
• Operating manual: BA 124F/00/en “Commuwin II” operating program
• An exact description of the data types can be found in the slot/index lists in the
“Description of Device Functions” manual.
As an aid in programming with Commuwin II, all of the Promag 53's device functions are
clearly arranged in a matrix.
Using the “MATRIX SELECTION” (VAH5) function, you can call up various parts of the
matrix.
To Next Page
Loading...
