Endress+Hauser Promag 53 - Page 76

5 Operation Promag 53 PROFIBUS-DP/-PA
76 Endress+Hauser
Device matrix
H9H8H7
DISP.VAL.STATUS (Display)
H6
EPD ELECTRODE (Options)
DISPLAY VALUE (Display) OVERVOLT. TIME (Entry, Service) DEVICE NAME (Display)
H5
OUT STATUS (Display) SYSTEM RESET (Selection) MEASURING PERIOD (Entry, Service) MATRIX SELECTION (Options)
H4
UNIT LENGTH (Options)
ERD RESPONSE TIME (Entry) OUT VALUE (Display) CHECK CONFIG.. (Display)
H3
OFF-VAL.LF-CUTOFF (Entry) ERD ADJUSTMENT (Auswahl) BLOCK SELECTION (Options) DEVICE ID (Display) POS. ZERO RETURN (Options) NOMINAL DIAMETER (Options, Service)
H2
DENSITY (Entry) UNIT DENSITY (Options)
STATUS ACCESS (Display) ON-VAL.LF-CUTOFF (Entry) SET UNIT TO BUS (Options) ACTUAL BAUDRATE (Display) INTEGRATION TIME (Entry) ZERO POINT (Entry, Service)
H1
CALC. MASSFLOW (Display) UNIT MASSFLOW (Options)
DEF. PRIVATE CODE (Entry) SELECTION GSD (Options) PROFILE VERSION (Display) SYSTEM DAMPING (Options) K-FACTOR NEGATIV (Entry, Service)
H0
VOLUME FLOW (Display) UNIT VOLUME FLOW (Options) ACCESS CODE (Entry) ASSIGN LF-CUTOFF (Options) EMPTY PIPE DET. (Options) WRITE PROTECT (Display) BUS-ADRESSE (Display) INSTL.DIR SENSOR (Options) K-FACTOTR POSITIV (Entry, Service) TAG NAME (Entry)
V0 MEASURING VALUES V1 SYSTEM UNITS V2 USER INTERFACE V3 LF-CUTOFF PARAM. V4 EPD PARAMETER V5 V6 PROFIBUS-DP/PA V7 PROFIBUS_INFO V8 SYSTEM PARAMETER V9 SENSOR DATA VA MEASURING POINT