Endress+Hauser Promag 53 - Page 82

5 Operation Promag 53 PROFIBUS-DP/-PA
82 Endress+Hauser
Totalizer Block (operation via profile)
H9H8H7
UNIT_MODE (Options) BATCH_OPERATION (Options)
H6
FAIL_TOT FAILSAFE_MODE
BATCH_PHASE (Entry)
H5
CHANNEL (Entry) ST_REVISION (Display) BATCH_RUP (Entry)
H4
TOTAL_LIMIT
SWITCH-OFF_POINT (Entry) SWITCH-OFF_POINT (Entry) SWITCH-OFF_POINT (Entry) SWITCH-OFF_POINT (Entry) BATCH_ID (Entry)
H3
TOTAL_SUB_STATUS MODE_TOTALIZER
SWITCH-ON POINT (Entry) SWITCH-ON POINT (Entry) SWITCH-ON POINT (Entry) SWITCH-ON POINT (Entry) PERMITTED (Display) PRFILE VERSION (Display)
H2
TOTAL_STATUS PRESET_TOTALIZER
ALARM STATE (Display) ALARM STATE (Display) ALARM STATE (Display) ALARM STATE (Display) NORMAL (Display) ALERT_KEY (Entry)
H1
TOTAL Status TOTAL_STATUS SET_TOTALIZER
VALUE (Display) VALUE (Display) VALUE (Display) VALUE (Display) ACTUAL (Display) DISABLE (Display) STRATEGY (Entry)
H0
TOTAL_VALUE TOTAL UNIT ALARM_HYSTERESIS HI_HI_LIM (Entry) HI_LIM (Entry) LO_LIM (Entry) LLO_LO_LIM (Entry) TARGET_MODE (Entry) CURRENT (Display) TAG (Entry)
V0 TOTALIZER V1 CONFIGURATION V2 ALARM LIMITS V3 HI HI ALARM V4 HI ALARM V5 LO ALARM V6 LO LO ALARM V7 V8 BLOCK MODE V9 ALARM CONFIG VA BLOCK PARAMETE