5.5 Operating parameters
Parameter Setting up selections
Default
settings
Actual
setting
User code
CODE
User presettable
operation code.
An already set code can only
be changed if the old code is
first entered and the unit
setting up released. Then a
new code can be set up.
Value:
0000 to 9999
There is no operation
code active if 0" is set.
0
* Set point code
LICOD
Set point changes require
or do not require a user
defined release code.
YES
Set points are user code
protected
NO
Set points can be
changed without setting a
user defined code
YES
This address is only active when a user defined operation code is set up.
Programme name
PNAME
Display address:
Display of the software
used in the unit.
Software version
SU-ID
Display address:
Display of the version
number of the software
used.
* Time trend
monitor
TRDT
The preset time value for
the trend monitor.
Value:
10 10 seconds
60 1 minute
600 10 minutes
10
This address is only available if the alarm set point option is active!
PARAM
Process transmitter
64
To Next Page
Loading...
