5.6 Linearisation table
The following addresses are only displayed in the setting up
menu if linearisation of the input signal has been selected.
Address
CURVE
is set to
TABLE
.
Parameter Setting up selections
Default
settings
Actual
setting
* Number of points
COUNT
Enter of the number of
linearisation points are to
be allocated.
The number of points can
be inceased at a later
time.
Number:
2to32
2
The first and last points are automatically set by the unit and are allocated the values
of sensor scale 0% (
SC LO
) to display value 0% (
DI LO
) and sensor scale 100%
(
SC H1
) to display value 100% (
DI HI
).
* Delete all
points
DEL
All linearisation points are
deleted to allow input of a
new linearisation curve.
YES
All linearisation points
are deleted after
acknowledgement
NO
All linearisation points
remain unchanged
NO
* Display all
points
LSHOW
In order to simplify
operation and setting up
it is advisable to blend
out all linearisation points
after they have been set
up.
The contents of the
points remains
unchanged and the
display can be switched
on again at any time.
YES
All linearisation points
are indicted in the
display
NO
The linearisation
points are blended
out
YES
TABLE
Process transmitter
66
To Next Page
Loading...
