Endress+Hauser TOCII CA72TOC - Replacing the Heated Salt Trap

TOCII CA72TOC Maintenance
Endress+Hauser 119
7.10.4 Replacing the heated salt trap
This section describes how the heated salt trap is replaced.
a0012515
Fig. 67: Position of the heated salt trap
You require the following parts:
• 4 mm Allen key
• Deionized water
• Heat-resistant gloves
a0012516
Fig. 68: Heated salt trap when installed
1 Retaining bracket
2 Heated salt trap with insulation
a0012517
Fig. 69: Heated salt trap, open
3 Allen screws
4 Filter housing, top section
5 Filter cartridge
6O-ring
1
2
3
3
4
5
6